M41A Pulse Rifle Build Guide

Welcome to the M41A Pulse Rifle build documentation.

Table of Contents

To build a current M41A from this file set…

Print the following:

Thompson

  1. All files in the M41A\Thompson\V2-2.5-3 folder
  2. All files in the M41A\Thompson\V2.5 Static Trigger Assembly Simple folder
  3. All files in the M41A\Thompson\V3 folder
     - Choose either the 6 stripe or 7 stripe handle

Remington

  1. All files in the M41A\V2.5 Remington folder

SPAS

  1. All files in the M41A\V2.5 SPAS folder
    • Choose either the standard SPAS cage “V2.5 SPAS” or the thicker solid lower version “V2.5 Thicker solid lower
    • Choose one of the front GL blocks

Front Barrel vents

  1. either a 10hole or 8 hole file in the M41A\V2.5 Front Vents folder

Shrouds

  1. all files in the \M41A\Shrouds\V3 folder
    • There is the option of a 1 piece rear shroud clip, which screws on to the shroud, or a left and right version that you glue onto the shroud.

The Airsoft and SD studios folders

  1. If you have an SD studios Stock, then print the following upper Thompson receiver instead:
    • “V3 SD Studios Thompson upper”
  2. If you have a 30 round airsoft mag you wish to use, there is an adapter in the Airsoft folder. You will need to gut the mag and cut the bottom off to suit.
    • There is also a vent holder that fits selected airsoft Thompsons.

Electronics

  1. If you are wanting to install electronics then substitute out what’s in here for your build.
    • The only things i do NOT include in this folder are the Speaker box and electronics frame, as i supply them with the full kit.
  2. I sell full kits through my website - www.paulsboutique3d.com

Version 3 Changes

Assembly Guides

Electronics & Components

Parts & Finishing

Last Updated: December 2025